diesel Fuel incinerators

diesel Fuel incinerators
16.  The supplier must provide necessary information for the best of the installation.  This incinerator with “PYROLYTIC” 
combustion must have:
17.  A combustion chamber of waste:
  Perfectly tight door for the manual loading of waste.  The loading should be manual, batch load.
  A burner of lighting which the use is limited to the ignition of waste.
  Frontage of loading with door seals gone up on hinges, wheel of screw plug, flexible joint, and stuffing insulating out 
of refractory.
  The insulation of the combustion chamber should be composed of refractory bricks, having a high content of aluminium and 
insulates bricks in order to assure a minimum temperature on the outside sheet metal.
  Composition of the refractory;
  Refractory concrete:
    Thickness :>100mm
    Nature: 42% of Al203
  Insulate in fibrous panels:
    Thickness: >75mm
  Nature: Calcium silicate.
  Burner of lighting of waste, with fuel, standard mono-bloc casting guiding plunging flame, lighting and safety of 
electronic ignition, permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.
  Plate of combustion in Carborundum, avoiding the fixing of glass and slags.
18.  A chamber of post combustion of gases
  A burner of combustion of gases,
  A device of injection of air allowing a total re-combustion of gases,
  A device of air inlet of cooling of waste gases,
  A sheath of evacuation of the gases burnt,
  Carcass in strong sheet steel with support of connection
  Composition of the refractory;
  Refractory concrete:
    Thickness :>150mm
    Nature: 65%% of Al203
  Insulate in fibrous panels:
    Thickness: >85mm
    Nature: Calcium
  Burner with fuel, mono-bloc casting guiding type with horizontal flame, lighting and safety of electronic ignition, 
permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.
  A secondary injection of air to ensure perfect oxygen content.